While riding yesterday I looked down at my fuel gage tank cap only to see it bouncing around like the lid on a tea pot. I pushed it back into the tank but it would not seal very well. When I got home I put a few dabs of silicone adhesive on the plastic liner and now it is in there real good. Anybody else experience a poor fit with their cap?
Also noticed a black plastic keeper of some sort dangling from the wire under the tank. Must have come loose from somewhere when I had the cap off while applying the sealant but I couldn't see where it was supposed to go so I just connected it to two portions of the wire and stuck it up under the tank as best I could.
Dan
Also noticed a black plastic keeper of some sort dangling from the wire under the tank. Must have come loose from somewhere when I had the cap off while applying the sealant but I couldn't see where it was supposed to go so I just connected it to two portions of the wire and stuck it up under the tank as best I could.
Dan