V-Twin Forum banner
1 - 1 of 10 Posts

· Premium Member
4,820 Posts
Whats Up! Apparently when the dealership acquired the police bike I currently own, done something to the wiring harness when they removed all the police equipment. I recently had a rear brake light issue, and have resolved that, but in the middle of doing that, I undone what they done to the harness under the seat, and now the bike wont start. Here is some pictures of what I'm dealing with.This under the seat, and the connected it to the harness that leads to the tail light. Any ideas or suggestions on this, thanks.
It's hard to tell from the picture, but it looks like something may have got hot. I'd probably start with the most basic and check the fuses. After that, if those wires are actually melted, I'd repair that by soldering in some new wire with proper insulation. I say, if that's the problem, as it is hard to tell from here.

Pretty much what Norm said.
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.