V-Twin Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
372 Posts
Got this littles tip from a HD Service school instructor.
Do not use shims on the rocker shafts, Instead relieve the center of the steel spacer the amount needed to take up end play. this needs to be done on a lathe.
Going high compression on prehistoric bikes is only good if you are going to run racing fuel.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top