V-Twin Forum banner
1 - 1 of 1 Posts

FLAME Ev'rything
65 Posts
76FLH said:
Well I'm not 100% sure about this, but I think you need to run two 6 volt
3 ohm coils in series because points like 5 ohm coils. Two 6 volt coils in series would be like a 12 voilt coil, Two 3 ohm coils in series would be 6 ohms. Does this sound right to you all? Lower than 5 ohms burns up the pionts.

I am sure about this, you want to run the timing at about 5 to 7 degrees less total advance. Two plugs give a faster better burn. Put the timing mark to the very front of the timing plug hole.

Plugs, you did not say if you have short or long reach plugs. I run Autolite 4265's on the long side (left) and 4275's on the short side (right).

Can I run Autolite 4265 Spark Plugs on a bone-stock '82 Shovel? Are they too hot? Too cold?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.