V-Twin Forum banner
1 - 1 of 4 Posts

· Registered
54 Posts
Same problem

I have a jims tranny...6 speed...the spacer is beveled on the ID of the spacer, just like above. If I was to put the beveled side in towards the tranny and the square, flat, side towards the final drive sprocket nothing would be pushing on the seal that just fits over the shaft.
Should the beveled side be facing out towards the sprocket?
When I pull the spacer out , fluid pours out..is this normal?

Thanks Guys.....
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.