V-Twin Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
6,406 Posts
cathari said:
FWIW, I have found that the torx set from harborfreight to be a handy set if you can accept an 'off shore package', and the only one this side of Snap-on that has the T27 size
Torx 3/8" sockets are available in any size you need for Harley from Sears tool catalog. Ones I have also have a removeable bit so you can replace it when necessary. NAPA sells bits with a lifetime warranty. You need mostly T25, T27, T40 and T45. Can't recall offhand any other sizes I've used on HD's but it's been a while since I wrenched on anything other than mine.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top