V-Twin Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter #1
Ok here it is.


I purchased a seII AC and yost power tube plus some cycle shack bolony
cut slip ons. fxdwg 03 tc88 it is not efi.

Now, While i am installing the yost power tube and have this carb apart
(stock CV) do i need to do anything else to it ie:
(Dynojet,Thunderslide)


thanks
skno
 

·
Banned
Joined
·
4,276 Posts
yeah, your gonna need to drill out the mixture screw cover on the bottom of the carb. 1/16" drill bit, then put a small screw into the hole. Only need about 3-4 threads into to cap, and pull it out w/ pliers. The plug is only about 1/8" thick so be careful. Some folks drill the slide for better throttle response. I did it, if I were you I wouldn't unless there is lagging response or it just doesn't feel right. Once you drill you can't go back. When you get all the goodies on the bike will be at a high idle. Turn your mixture screw IN untill the enging stumbles the back it out 2 to 2 1/2 turns and take her for a spin. Here is a good guide -> http://www.nightrider.com/biketech/hd_cv_mods.htm
and tuning -> http://www.nightrider.com/biketech/carbadjust.htm
 

·
Registered
Joined
·
76 Posts
Discussion Starter #4
Will do Habanero kid,


Yes I do like the nightriderr sight, I have referenced it many times
while thinking this install though.

Yes i gotcha on the idle mix screw. Easy does it with the drillbit and sheet metal screw.

skno
 
1 - 4 of 4 Posts
Top