V-Twin Forum banner

Throttle cable replacement

Jump to Latest Follow

1 - 1 of 1 Posts
V

·
Registered
Joined
·
1 Posts
Discussion Starter • #1 •
I just put drag bars on my 96 1200C and the existing throttle cables were to long. I purchased factory cables for a late model 1200C (one with drag bars form factory) and am trying to figure out how to change them at the carb side. Do I need to take carb off or tank off to do this change over?:confused:
 
1 - 1 of 1 Posts
Recommended Reading
Read More

  1. Troubleshooting low performance, compression test results and whats acceptable

    Twin-Cam Engine
    So, Ive got two FXDX bikes. One, a 99, the other an 04, carbed, and both have comparable mods. The 99 has 37k miles, a Thunderheader, Big Sucker intake, stock pistons and SE 204 cams, and made 86 lb ft and 79 hp on the dyno. The 04 has 56k miles, a Supertrapp 2-1 with closed end...

  2. Lowering compression with gasket thicknesses

    Twin-Cam Engine
    Converting my 88 to a 95 and the pistons I have are specific to my heads, so I'm not getting different ones, but they're rated at 10.5:1 compression which is a little more aggressive than I'd like for this particular bike. My question is how much gasket thickness should I use to get that...

  3. Adjustable pushrods

    Twin-Cam Engine
    I am sure this has been asked and answered s million times. Sorry in advance. What are the thoughts on these brands of quick install versions? Screamin Eagle Andrew's S&S Smith brothers? (Havf a set that can utilize the factory pushrod tubes apparently) Sent from my SM-G960W using Tapatalk

  5. Andrew's 48H vs Andrew's 57H for my 96"

    Twin-Cam Engine
    What cam would work best in my 2010 SG stock 96"motor? A 48H or 57H The 48H max [email protected] rpm and the 57H 2200-5600rpm. I want a cam that comes on reasonably early. The 57H seems to come on a bit earlier and go out a bit further at the same time. What is it that I am missing here. If...

  6. Maybe dumb question

    Twin-Cam Engine
    I recently purchased my first Harley a 2001 Fat Boy FI. Best bike I have owned. I want to start making some changes to fir my own style. One of the things I want to do is remove the dash panels and have them powder coated. Looks to be a pretty simple job to remove it and all the parts...
Read More
About this Discussion
0 Replies
1 Participant
Last post:
VinceM
V-Twin Forum
V-Twin Harley Davidson forum. Discussion on V-Twin Harley Davidson motorcycles including Dyna, Electra Glide, Softail, Sportster, and more.
Full Forum Listing
Explore Our Forums
General Harley Talk Twin-Cam Engine Religion & Politics Off Topic Discussion Harley-Davidson Touring
Popular Communities
Community avatar for Mountain Bike Reviews
Mountain Bike Reviews
450,000+ members
Join
Community avatar for Home Improvement
Home Improvement
290,000+ members
Join
Top