[IB Fubar]

Want tech in Sacramento Area NOT DEALERSHIP!!. Have not worked on V-Twin motors .They cant be different than Fords or chevys.Just have problems that i dont know how to check!! E-Mail [email protected]

 

[DaveCarlson]

Why not ask a few questions here? You're a member on this forum....

Just sayin'

 

[wurk_truk]

Absolutely ask questions here even if you end up not doing the work yourself. The combined knowledge here is quite a lot.

We can help you do whatever yourself, too... if you have the correct tools, manual and inclination. Nothing really 'harder' than working old Chevy SBs.

Here ya go. This will get you in the correct direction on the pushrods. Be sure to click the Bog Boyz links in the thread and read them.

http://www.v-twinforum.com/forums/twin-cam-engine-mods/162068-hydraulic-lifter-pre-load.html

 

[secondchance]

This is a Great place to find good info.But back to your question,I do know a Good tech in the Sacramento area.He does have a shop in Rancho Cordova.It's Full Throttle performance,his name is Mike,give him a call.They have a web site.If you can't find the # let me know,I have somewhere.

 

[IB Fubar]

Thanks secondchance!! Mike was contacted and my ride goes in the 7th for help and my teaching on how to adjust them. Also a fuel pressure check (dont have the correct test equipment. Replaced the ex gaskets today 6th and the valve pocket are EXTRA CLEAN.LEAN!! I think that maybe the jerking is a lean condition so im checking into that also.Thanks AGAIN!!!!Gene