V-Twin Forum banner

Stock ECM Map?

1432 Views 3 Replies 3 Participants Last post by  Billman
Hey,
How/where can I get the stock ECM Map for my bike ('06 Night Train)? I assume the dealer would have it, but I'd probably have to pay for it. Is there a way to reset an ECM back to factory defaults?

I loaded the appropriate map for the mods I will be doing to my bike, but don't have all the parts for the mods (was informed today that some of the parts for the Poormans SE A/C won't be here for a week or so). So I would like to continue to ride my bike in its stock state, but i don't have the stock ECM map. Thanks alot, and happy holidays...
1 - 4 of 4 Posts
petrock said:
Hey,
How/where can I get the stock ECM Map for my bike ('06 Night Train)? I assume the dealer would have it, but I'd probably have to pay for it. Is there a way to reset an ECM back to factory defaults?

I loaded the appropriate map for the mods I will be doing to my bike, but don't have all the parts for the mods (was informed today that some of the parts for the Poormans SE A/C won't be here for a week or so). So I would like to continue to ride my bike in its stock state, but i don't have the stock ECM map. Thanks alot, and happy holidays...
If you downloaded a stage 1 map it will most likely run better even stock. Getting the stock map reinstalled has to be done at the dealer. Don't sweat it, just ride it!
RB
Yeah, I downloaded Calibration #23 from the SERT (2006 Softail and Dyna Models w/ Shotgun/Shorty Dual Exhaust, 1450 SE A/C & Mufflers, File: 141NP001-A0.MT6). I'm just worried I'd mess something up if I rode it... Thanks alot...

---Rob
I'm about to load the same MAP into my bike without the A/C Mod. All I've got on are the pipes. I'm waiting for the '06 version of the Big Sucker.

I wouldn't doubt the bike runs better with the additional fuel.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top