V-Twin Forum banner

Smith Brothers push rods

4982 Views 11 Replies 7 Participants Last post by  DURWOOD
These are what I am installing in my 117" build.I wanted to address my valve train stability and they should be up to the task.
7/16 to 3/8 taper,.165 wall thickness. 3/8 threads cut into the chromoly rod ends.24 TPI.
And as part of the give and take aspect,these rods are 45 grams/each heavier than my Feuling .095 wall adjustables.
This is Not going to be a high mileage build and valvetrain life is being taken into consideration.They are going to be paired up with Wood lifters and S&S rollers on S&S 675 cams.


See less See more
1 - 1 of 12 Posts
...Pulled them,measured them and smiths made a set of solids .120 wall for me in 1 day.
I'm a big proponent of a 1-pc. pushrod!!

jam65 said:
A couple weekends of assembly,baring major unforseen issues and depending on Strokers schedule......We shall see.
Can't wait!! :corn:

1 - 1 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.