V-Twin Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter #1
Hey guys. I havent had to strip a bike before and am stuck. How do I pull a clutch basket without a puller? The nut is reverse thread isnt it? Do I need to pull the pushrod? Thanks in advance.
Pete
Perth Australia
 

·
Registered
Joined
·
177 Posts
To remove the clutch hub without a puller: Reinstall the clutch nut ( without the lockwasher) and thread it onto the mainshaft until it touches the clutch hub. Then back the nut out 2 turns. Slide a 1 1/8 in deep socket over the clutch nut and push it so that it seats against the clutch hub. Hit the socket squarely with a hammer to shock the hub loose. Remove the clutch nut and slide the clutch hub off the mainshaft. Hub nut is left hand thread. Good luck
 
1 - 2 of 2 Posts
Top