V-Twin Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
487 Posts
i made a spreader that goes between the top mount and the frame saves time less taking apart non problem peices
 

·
Registered
Joined
·
487 Posts
ok its a couple of aluminum plate hinged at one end chat clamps to the top motor mount and a swivel foot forcing screw that as turned in pushes the top plate up against the frame to push the engine down against the mounts to gain room to remove the rear box easier and it what easier and safer than what i use to do and that was use a rachet strap around the bottom of frame and over the top of trans motor junction caution must be used not to pinch a hose or wire and cinch up gaining clearance to service the rear box
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top