V-Twin Forum banner

1 - 20 of 28 Posts

·
Let er rip!
Joined
·
2,876 Posts
Discussion Starter #1
I know this isn't the classified section. I'm just not sure how often everyone cruises the classified section.

Anyway, I have the R&R Stage 2 1/2 CNC ported heads for sale. They have the GMR goodies in them. 1.9 intake, 1.615 cut down to 1.575 exhaust, and set up for .620 lift. About 1,500 miles on them. Randy cleaned them up and put new seals on yesterday. They dynoed 104/108 on my 98" with Rinehart staggered duals. I'll post pics when I figure out what my daughter did with my camera. :spank: LOL!

I think they're around $850 with exchange. I'm looking to get $650 for them, and no exchange. I have the SE Intake I'll throw in there as well.
 

·
Let er rip!
Joined
·
2,876 Posts
Discussion Starter #3
brassman said:
are they black powder coat? what
cams were they matched to in your
build?
Yep, black powder. I forgot to mention that.

I don't think anything was done to the heads to match the cams. Other than springs for up to .620 of lift. Steve can maybe answer that question. The cylinders may have be shaved a tad for proper quench, or whatever it's called. Anyway, it was the 615/585 cams with these heads that dynoed 104/108.
 

·
Let er rip!
Joined
·
2,876 Posts
Discussion Starter #5
I also forgot to add that they have the compression releases installed.
 

·
Let er rip!
Joined
·
2,876 Posts
Discussion Starter #8
I did a 107" with R&R Stage 5 cast heads.
 

·
Let er rip!
Joined
·
2,876 Posts
Discussion Starter #9
I think the cc volume might be 89 on these heads

Not totally sure. I asked the question in the engine mods section.
 

·
Let er rip!
Joined
·
2,876 Posts
Discussion Starter #10
I guess the 8915 on the heads are a work order that can be tracked

not the cc like I had guessed
 

·
Let er rip!
Joined
·
2,876 Posts
Discussion Starter #11
Okay, Steve says they should be 84 cc's.
 

·
Let er rip!
Joined
·
2,876 Posts
Discussion Starter #12
 

·
Let er rip!
Joined
·
2,876 Posts
Discussion Starter #13
Mind if I BUMP???
 

·
Let er rip!
Joined
·
2,876 Posts
Discussion Starter #15
YankeeBob said:
Mind if I FART???
Thanks for the BUMP!!!!! :cheers:
 

·
Let er rip!
Joined
·
2,876 Posts
Discussion Starter #17
Found some head bolt covers to toss in the deal..... :xhere:
 

·
Let er rip!
Joined
·
2,876 Posts
Discussion Starter #18
599 views and counting...... :coffee:
 

·
Let er rip!
Joined
·
2,876 Posts
Discussion Starter #19
Free shipping is on the table.

If I have this figured out right, this is over $300 in savings. Damn close to $400 by the time you figure in selling your old heads. Even if you sell them for $100, it's still a $300 savings. :thanks:
 

·
Registered
Joined
·
474 Posts
would Someone buy these Heads so this thread dont keep poping up! :yawn:
 
1 - 20 of 28 Posts
Top