V-Twin Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
121 Posts
Re: M6 install

fcoxwell said:
2001 and up M6 tensioners for Big Twins require you to remove the two phillips screws everyone has been talking about to install a longer bolt.
You will need a new gasket cause you have to take the primary cover off.
You have to take the primary cover off for the 2000 and older also.
The phillips screws are big and I used hammer and an impact tool with a #4 phillips bit to remove the screws. I used the impact tool to tighten them up with along with some locktite.

The included instructions are very clear and easy to follow. Wally's Cycle has the M6 for about $50.00
Do you mean the inspection cover or the whole primary cover?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top