V-Twin Forum banner
1 - 10 of 10 Posts

·
Premium Member
Joined
·
110 Posts
Discussion Starter · #1 ·
Can any one help?
I just hooked up my Power Commander and am having some problems. I bring up the map #809-020 turn on the key, download the map to the PCIIIr, the verify tables sent comes up on the computer, the engine light stays on and the light on the on the PC is in the leanest position and the bike just turns over but wont start. Someone please help if not I will have tocall Dynojet tommorow and see if I can get it worked out. Thanks in advance for any help
Kevin
 

·
Registered
Joined
·
913 Posts
Have you tried loading the stock map (M809-001) just to see if it will start at all?
 

·
Registered
Joined
·
913 Posts
Thanks.

Also make sure you are loading the map to the position you are planning to use. You can always load the map to all three positions.
 

·
Registered
Joined
·
913 Posts
Look at the instructions. The PCIII will hold three maps. You then choose the position with the buttons. Pretty simple, you just have to follow the instructions.
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top