V-Twin Forum banner
1 - 6 of 7 Posts

·
Premium Member
Joined
·
172 Posts
Discussion Starter · #1 · (Edited)
I need to know the bolt hole pattern dimensions on the tranny to make a bracket to fit on a floor monuted engine stand. I have everything made except for the mounting plate. This stand will allow me to rotate engine 90 degrees. If I am not clear enough on the description please let me know.

:beer4u: Thanks
 

·
Premium Member
Joined
·
172 Posts
Discussion Starter · #3 ·
Thanks, but all I need is the dimensions of the bolt hole pattern so I can make the swivel mounting bracket to place on the rear of the motor. The stand is all ready done. Thanks
 

·
Premium Member
Joined
·
172 Posts
Discussion Starter · #5 ·
Thanks, if you come across a B i sure would appriciate it. I just don't like the idea of laying my motor or just setting it on the bench until I get the bracket made.
 

·
Premium Member
Joined
·
172 Posts
Discussion Starter · #7 ·
Google search only gave me adapter plates for twin cams to install in EVO frames. The Dimesions displayed are for the offsets need for tire. Thanks
 

·
Premium Member
Joined
·
172 Posts
Discussion Starter · #10 · (Edited)
Sorry, new at this! I may not have the correct dimesions after all. I will be pulling motor this week so I will find out for sure and list them.
 

·
Premium Member
Joined
·
172 Posts
Discussion Starter · #11 · (Edited)
88B engine stand hole pattern

rhaubert said:
I need to know the bolt hole pattern dimensions on the tranny to make a bracket to fit on a floor monuted engine stand. I have everything made except for the mounting plate. This stand will allow me to rotate engine 90 degrees. If I am not clear enough on the description please let me know.

:beer4u: Thanks
Here is a pdf with dimensions. You will need to make bosses (at least 2" long with 3/8 bolt clearance hole in them), to clear the counterbalance area in the cases. I can give you the dimensions just drop me a line.
 
1 - 6 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top