V-Twin Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
139 Posts
Discussion Starter #1
Ok. I am on the final steps of installing the passing lamps on my 2002 1200 Custom Sportster and need help with the rubber grommet on the back of the headlamp. The instructions state to install the thin black wire into the grommet and splice it to the yellow wire. I do not see any way of getting the wire to penetrate the rubber grommet. Any suggestions?

I have attached a picture of the grommett.
 

·
Ridge Rider
Joined
·
435 Posts
Straighten a paper clip and make a small hook on one end. Attach the wire to the hook and wrap with electrical tape. Push the clip through the grommet and pull the wire through.
 

·
Registered
Joined
·
139 Posts
Discussion Starter #4
IT WORKED. :cool:

On to finalizing the job. I will post pictures when I am finished. What a difference this makes in the appearance of my bike. Now I can really say YES to all my friends when they say did you do that yourself. I suppose they assume because I am a chick I can not do these things. Actually, I am schocking myself.

Thanks!!!
 
1 - 5 of 5 Posts
Top