V-Twin Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Hi guys & Gals,
I've got a TC95 with a Mikuni HSR42 carb, flowed heads, Andrews TW-21 cams and V&H Propipe exhaust. I just got it back from my wrench and need a good baseline jetting for my carb for break-in. Anyone out there have a similar setup?

thanks,
C-B
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #2 ·
ok, for the benefit of the readers

This forum is quite dead, but I'll post my findings for the benefit of others that may have the same question.

97 needle with clip in middle.....70 pump nozzle
27.5 pilot..............................165 main

GENTLY bottom the air mixture screw and then open it 2 turns.

C-B
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #4 ·
Wrench a quack

Calling the guy that did the work on my bike a wrench is a compliment that he does not deserve. I almost sued him over the crap job that he did, but decided that it wasn't worth my time and trouble.
C-B
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top