[SCARYGLIDE]

(Bike is a '92 Electraglide, 93,000 miles.)
This weekend while on a run, we pulled over after an hour or so of running.
When I let the clutch out to get going again I got a grinding noise and no bike movement.
It is a slow grind in first gear, and a fast grind in high gear.
I suspect the belt drive pulley has come loose or stripped.
Haven't had a chance to get it up on the lift, just wondering if this sounds familiar to anyone.
Might be the perfect time to stuff an Ultima 6 speed convo set in, eh?
Thougts on the Ultima set?
Thanks,
Mike

 

[SCARYGLIDE]

Update...

I got the bike on the lift table last night, and jacked the rear wheel off the table.
I put the bike in gear, and as I turned the rear wheel, the drive pulley turned on the output shaft, with a clicking sound. :crying:
Does that sound like a stripped pulley, or is it an internal tranny problem? (Guesses are accepted too.)
The pulley has a definite belt wear groove on it.
Thanks,
Mike