V-Twin Forum banner

Lowered My Fatboy..now Have Questions

854 Views 2 Replies 2 Participants Last post by  02FATBOY
I forgot to measure stock height, can someone tell what that is and from which points are you measuring from. Also I think I may have lowered it 1" but I have a hard time getting my lift to go under frame. Is this normal or have I lowered it too much. I just want to make sure I'm not going to screw any thing up. THANK YOU!!!
1 - 3 of 3 Posts
If you are talking about ground clearance, then 5.1 inches according to the specs on the HD website, but I don't know where they are measuring it from. I bought a used 2000 fatboy and can't get my craftsman lift under it until I run the bike up on two seperate pieces of 3/4 inch plyboard. A little inconvient, but the price was right on the lift.
THANK YOU!!! I think I know where they measured from.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top