V-Twin Forum banner

1 - 11 of 11 Posts

·
Arrogant Bastard
Joined
·
1,264 Posts
Discussion Starter #1
Okay, now that you guys have talked me out of just doing cams, I need to find a good builder in Northern California(preferably Sacramento area) that can do a 95", gear drive cams and porting.

Thanks,
Joe
 

·
Arrogant Bastard
Joined
·
1,264 Posts
Discussion Starter #2
Ttt

keeping it in view
 

·
Premium Member
Joined
·
3,122 Posts
jasilva said:
Okay, now that you guys have talked me out of just doing cams, I need to find a good builder in Northern California(preferably Sacramento area) that can do a 95", gear drive cams and porting.

Thanks,
Joe
If Reno's not too far, Freedom Cycle is great.
 

·
Arrogant Bastard
Joined
·
1,264 Posts
Discussion Starter #4
Too cold!

nvsteve said:
If Reno's not too far, Freedom Cycle is great.
It's not too far but for a winter time job it's a bit too cold getting there. Thanks for the tip though.

Joe
 

·
Arrogant Bastard
Joined
·
1,264 Posts
Discussion Starter #5
Putting it back up top
 

·
Arrogant Bastard
Joined
·
1,264 Posts
Discussion Starter #7
DrHeathenScum said:
If Hayward isn't too far, Ron Cairns @ RC Cycles, Hayward is a GREAT engine builder... the man puts in the time.
Thanks, I hadn't thought of him.

Joe
 

·
Premium Member
Joined
·
16 Posts
RC Cycles

I will second the RC Cycles advice. I have the RC 95" full port on my 2001 FLTR. The dyno turns 112/112 with S&S gear drive cams. The cams are a RC Cycles grind called the RC23, the pistons are Mahle, etc. Also, Ron is as honest as they come.
 

·
Registered
Joined
·
134 Posts
How about BC Gerolamy in Rancho Cordova. They've been in the business a long time.
Also, Bachmann's in Woodland has a good reputation.
 
1 - 11 of 11 Posts
Top