V-Twin Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
129 Posts
Hab, My heads and jugs are on the way back from Short Block Charlie's as I write this. As was said above, if you are going to have it apart to do the heads, do the 95" at the same time. Cost is only about $250 to have the jugs bored and a set of SE flat tops fitted.

My Glide should be finished up by the second week on Nov. I'll post results then.
Ken
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top