Foot pegs
Join the discussion
Recommended Reading
-
Troubleshooting low performance, compression test results and whats acceptable
Twin-Cam EngineSo, Ive got two FXDX bikes. One, a 99, the other an 04, carbed, and both have comparable mods. The 99 has 37k miles, a Thunderheader, Big Sucker intake, stock pistons and SE 204 cams, and made 86 lb ft and 79 hp on the dyno. The 04 has 56k miles, a Supertrapp 2-1 with closed end...- 10
- 388
-
Andrew's 48H vs Andrew's 57H for my 96"
Twin-Cam EngineWhat cam would work best in my 2010 SG stock 96"motor? A 48H or 57H The 48H max [email protected] rpm and the 57H 2200-5600rpm. I want a cam that comes on reasonably early. The 57H seems to come on a bit earlier and go out a bit further at the same time. What is it that I am missing here. If...- 1
- 72
-
Engine wont turn over when in gear and clutch disengaged
Twin-Cam Engine2015 FXDWG. It would work on occasion but lately not at all. Any info I can get will b appreciated.- 4
- 85
-
Marksh · updated
-
2000 FXDX Clutch help, Tight after cable replacement.
Twin-Cam EngineLong story here but relevant for properly trouble shooting my issue. It all started when my 2000 FXDX developed an extremely bad primary leak at the main drive seal and trans seal. I live in NYC and have extremly limted soace to do maintenance and in the past replacing those seals is a mother...- 9
- 386
-
After market Tensioners
Twin-Cam EngineI am updating my 06 to a newer stock cam plate ( 2013) using the Andrews N cams etc.. Using new inner cam bearings, new lifters and I am going to pull my tank and reuse the stock pushrods, so I will be installing the " rocker lockers" while its apart.. My question here is I was going to...- 94
- 5K
-
duuude · updated
Join now to ask and comment!