V-Twin Forum banner
1 - 1 of 6 Posts

· Premium Member
173 Posts
Hello, if your clutch works like my old one did, you loosen up the lock nut on the adjuster and back it all the way off, then put a very large washer over the adj. stud and put the nut back on. Screw it down till you can remove the 3 outside nuts, then you just pull it all out one peice at a time. Done
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.