V-Twin Forum banner
1 - 2 of 2 Posts

· Registered
2,100 Posts
You don't drill out the screw, you just remove the plug that covers the screw. You take a small drill bit like 1/8" or close to it and drill slightly into the plug (make sure you do not drill thru it) just enough to where a sheet metal screw will hold in the hole you just drilled and then you pull on the screw with a pair of pliers so as to remove the plug.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.