V-Twin Forum banner

21 - 30 of 30 Posts

·
not sober all the time
Joined
·
5,525 Posts
I have a J&S and it seems like I still should have the frame adapters for my 2008 Super Glide Custom. Where are you placing the arms to clear everything?

Sent from my Pixel 3a using Tapatalk
Position the rear pad just behind the "shark fin." (view from right side)
265563



That puts the front pad just in front of the kick stand. (view from the left side)

265562
 

·
Registered
Joined
·
123 Posts
I did same to mine ( as FWDWG03 did to his ) 1/2 bolts, reamed holes also.
The only difference is I cut cross bar and then beat a 12” x 3/8 “ pipe inside.
However with cross member pipe still in place it will only lower to 6”, enough for me … but if not enough you could re-weld back farther.
Widened by 6”… now a little over 12 1/2” between platforms.

I have an older Dyna , so no issues with the fin, but it is definitely easier to miss jiffy stand & drain plug & sump. Seem to have good stability.

D70F8CBD-AF38-4B11-B6ED-594EBE07BAE9.jpeg C0600221-D2EA-4A7C-B3AB-09EB52DB0731.jpeg D42FFAD4-A076-4EFD-9DCC-11606F5756B2.jpeg
 

·
Registered
Joined
·
30 Posts
Discussion Starter #27
Can’t find one, anybody modify other brands for the Dyna?
I found a Black Jack Porta Lift. I took the 2 inner pads off and spaced out the outer pads half inch per side,
( should of went more) but it works.
Adjustments.jpg



Sent from my iPhone using Tapatalk
 
21 - 30 of 30 Posts
Top