V-Twin Forum banner

Cleaned Up Rear Fender

2K views 10 replies 5 participants last post by  GrampsWyatt 
#1 ·
I finally cleaned up the rear fender on 07 FLSTF. I have a lic plate holder on the way to relocate to side of frame. Anyway, used led's w/smoke lens and I am likin the low profile tail light more and more. Used Biketronics Equalizer & Tailbones modules for running/brake/signal out of turn signals.






 
See less See more
4
#5 ·
Tail light is low profile w/smoked lens. P/N 4959
http://www.customdynamics.com/harley_davidson_motorcycle_led_taillight.htm

Blinker w/smoked lens red light. P/N 4827
http://www.customdynamics.com/Harley_Davidson_Motorcycle_LED_Turn_Signal.htm

I've always HATED solder connections. I can't solder worth a darn. These look pretty neat, anyone use em? Posi-Lock watertight connectors?
http://www.customdynamics.com/posilock_connectors.htm

I'll try and get some pix at night in cpl hours.

I used the Biketronics Tailbones (Run/Brake/Signal) and the Smart Equalizer (for led signals) because I heard other equalizers get really hot in this application.
 
#6 ·
hmmm....love the low profile just not sure if I like the smoked or stock red. I have the Vivid Black FatBoy I guess the smoked might blend in well but I also have red graphic and stripes on the tank and fenders so the red tailight might compliment also.
 
#11 ·
Ron I just put the equalizer and tailbobe modules between the battery and ecm underneath the seat, then bundled up the wire/connectors and put them there also. There was plenty of room underneath seat. The 2 modules are in series when placed in-line where the main harness and rear tailight harness are connected.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top