V-Twin Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
19 Posts
Tool Rental

Just wanted to see if you are still renting out the cam installation tools? I would like to do the install sometime this fall but I do not have the cams ordered yet. Thank you From Springfield, MO​

rsed said:
I am offering to the members of this forum the oppertunity to rent the tools needed to replace the cams and inner and outer bearings of their TC motors.
The price for rental is $50.00 deposit plus shipping. Upon return of the tools you will get back $15.00. For a total cost of $35.00, of which $5.00 goes to DPrice for the upkeep and costs of running this forum.
I will take either money order or PayPal.
The tools include:
JIMS? TWIN CAM 88" CAMSHAFT REMOVER AND INSTALLER
JIMS? TWIN CAMtm CAM AND CRANK SPROCKET LOCK TOOL
TWIN CAM 88 CAM BEARING INSTALLER AND REMOVER
2 EVO Tappet Block Alignment Tools for Aligning the Oil Pump

It does not incude the Cam Chain Tensioner Tool, a pair of channel lock plierers and allen wrenches will work for holding the chain tensioners in place.
You must have or acces to a press to use these tools. There is NO need to us a hammer on any of these tools.

To rent these tools e-mail me at [email protected] .com I will post who is getting the tools in the order in which they are requested.
Donot rent these tools if you are not ready to use them. The time limit for rental is one week. It only takes about 1 hour to change out the cams and bearings once you have the cam cavity opened up.

I am doing this to help out the fellow riders on this board. PLEASE donot disapoint me or other members who might want to take advantage of this offer by not returning the tools when done.

Thank You,

St. Louis Bob
2001 FLHTCUI Lux. Rich Red
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top