V-Twin Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
276 Posts
Discussion Starter #1
Sorry guys, I know this is in here somewhere but I couldn't find it.
Just had 95" intalled. How many miles before it's ok to dyno tune? Thanks.
 

·
Registered
Joined
·
6,413 Posts
Considering you've got new cylinders and rings, same as brand new bike as far as I'm concerned. Others may disagree.
 

·
Registered
Joined
·
276 Posts
Discussion Starter #3
Didn't get new cylinders, just had them bored out so really I'm just seating the rings. Wouldn't think it would be as long as a new motor. But not sure.........
 

·
old timer
Joined
·
516 Posts
If the rings aren't seated in 50 miles you have a problem. If you used cast iron rings 50-100 miles is plenty. Chromoly rings might take 250.

manny
 

·
IronButt
Joined
·
6,364 Posts
Opinoins vary on that. I have done 95 kit put 25 miles on it and put it on the dyno. Others want 500 min. But most high proformance shops will put their work on the dyno shortly after putting motor together, I would want 25- 50 miles on the motor before dyno. Good luck Hope it pulls some good numbers for you
 
1 - 5 of 5 Posts
Top