V-Twin Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
hey all, i have a 2001 softail standard. i bought the bike used, and decided to change the 16" apes to a low profile crazy z bar. the wires pulled through slick no problems, all wires hooked up just as they were colors all matching. i have to admit i forgot to disconect the battery. now when i turn the ignition switch i have all power to left side, horn, left turn signal and high/low beam. on the right i have no power at all. when i turn the ignition switch on the turn signal lights on flash as does rear turn signals then it stops and the bike should be ready to start. and it does not. ( the previous owner had removed front turn signals.) my buddy brought over a new module we hooked it up and still nothing. any ideas, please help, we are totally lost!! Joe :confused:
 

·
Registered
Joined
·
552 Posts
Disconnect the battery now, check fuses, then re-connect battery.....probably fire up for ya.
I'm going for a good ride today, where you at in Ohio?
 
1 - 4 of 4 Posts
Top