[jamercier]

i build an evo with 97ci axtell kit ,mill head .065 ,ported head , 1.900in and 1.615 ex ,155lb spring valve ,.040 head gasket..ccp195 psi. s&s reed valve fuiling tappet ,adjust.pushrod. a42 mikuni carb ..i have already three cams ,,a 300-2b crane, a 326-2b crane and a andrew ev-27..

witch cam will be the good one or maybe an other one ... thanks

and btw how much would be appromax the hp\tq number

 

[cernunos]

Halloo. Which cam is in it right now? At 195 ccp I would think the 300 is in it. I would throw the 326 in and see how that feels. HP and TQ?? Really depends, but I would think you could get around 100, give or take, each one, depending on exhaust, timing, etc.

C.......

 

[jamercier]

the 326 is in now but i feels he will start to late to get on maybe 3000rpm not my style i want it. plus in the range of 2200-2400rpm iam looking maybe for a compcam 2040

 

[cernunos]

Halloo. Woohooo, definitely got some compression ratio there, around 10.75-11?? I would NOT put the 300 in. Used one with 10:1 c/r and was a hard starter, detonated, but pulled REAL hard up to around 4000. Of the three you have, if you want a little more down low, I would go with the EV27. How about the Crane 316? Wanted to try it myself but could not find one. Good specs for a higher compression motor, low lift so it is still easy on the valve train.

C......

 

[Springermike]

I really like the W6 or if you have the lift the W8 would run great too .

 

[jamercier]

so i put the bike on the dyno and i got 102 hp - 100 tq with the crane 326 -2b and it start at 1500rpm-83tq ,,,2000rpm-85tq,,, 2500rpm-100 tq up to5000rpm and comeback to 80tq at6300 rpm for the hp it go up to102 till 5700 rpm and is 95 hp at 6500rmp and that seem good for me