V-Twin Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
This is the first time attempting to install a trans in a 1000 and are those rollers a pain to keep in position while installing the trans.Before I go any further is there anyone that can tell me how hard that the assembly is suppose to go in.I had a hell of a time to seat all the way.The rollers are in right as far as I can tell.Also is there a different bearing that can be used instead of the roller/race setup.I don't care if I have to pull the trans again I just want to make sure that I have it right the first time.The manual isn't clear on these things.

Thanks,
Harv
 
1 - 1 of 1 Posts
Top