I picked up a set of sheet metal for my 2002 Fatboy to have a custom paint job done, and I wanted to save my original paint set. The set I picked up is for a 2001 Fatboy. I have noticed that some 2002 rear fenders have 2 holes at the rear portion of the fender (where the turnsignals mount to the strut) and some have 3 holes (these are the holes that are close together and are at the rear most part of the strut). I have also noticed this on 2001 model rear fenders - Anyone have any Ideas? Are 2001 and 2002 rear fenders supposed to be drilled the same?
2002 Fatboy rear fender - Is it different from 01 model?
1 - 3 of 3 Posts
Howdy, I believe the set I swapped out on my 2001 FLSTFI was from a 2002 and there was no difference.
There may be a few differences in the holes, but the sheetmetal is the same. You should have no problems. Derk
1 - 3 of 3 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
V-Twin Forum
V-Twin Harley Davidson forum. Discussion on V-Twin Harley Davidson motorcycles including Dyna, Electra Glide, Softail, Sportster, and more.
Full Forum Listing
Join now to ask and comment!
