A customer bought an '08 Road King and wanted the same bars he had on his Softail. The bars were not designed for the new '08 with Throttle By Wire.
This first picture shows the new Throttle By Wire in the handlebar end.
![Image]()
The first step in removing the throttle is removing the pins from the connector and pulling the wire out of the handlebar. This picture shows the wires entering the bars at the clamp.
![Image]()
With a small screw driver or pick, carefully pry the assembly out of the bar.
![Image]()
Slide the assembly out.
![Image]()
![Image]()
This first picture shows the new Throttle By Wire in the handlebar end.
The first step in removing the throttle is removing the pins from the connector and pulling the wire out of the handlebar. This picture shows the wires entering the bars at the clamp.
With a small screw driver or pick, carefully pry the assembly out of the bar.
Slide the assembly out.
