I have to feather the clutch when starting off. The only ways to keep the bike from stalling is to roll at 1500 rpm while slipping the clutch, or I can launch hard then roll off the gas. Neather way works well all the time. If I try to idle off bike will stall. When you are on an incline it gets very interesting. Thank God for Engine Guards!
__________________
Gas, Grass or Ass! Nobody rides for free
Hey you didnt mention what your bike is and what year it is. Im assuming its carburated. Does it run ok at higher engine speeds? Does it start hard? Is the power low.
The HD dealer reinstalled the braided clutch line when I had the set back bars & vrsc raisers installed. Is there an ajustment to the hydraulic clutch that was missed?
Thanks
__________________
Gas, Grass or Ass! Nobody rides for free
Hey you didnt mention what your bike is and what year it is. Im assuming its carburated. Does it run ok at higher engine speeds? Does it start hard? Is the power low.
04' vrscb, electronic injection, will put the fear of HD in a crotch rocket for a good block
__________________
Gas, Grass or Ass! Nobody rides for free
Stalling when starting off in 1st.
Linear Mode
