|
Head Fixture Pics For Hdryder
Hdryder, here's the pics we talked about in the exhaust port thread. You should be able to see the fixture I was talking about which attaches to the R-8 adapter. It sounds like correcting any deviations would be difficult on the plate you made,but it may not be necessary if you're close I guess.
I also showed a paper which shows how I correct deviations in runout after the first cut, if any are present. The #'s other than 0 on the X &Y axis's are all positive,and the #'s in thousands are deviations from the zero's on the DRO.
I also put in a pic of a piston set up for flycutting, probably easy to add to your plate, and quicker than a piston vise. I've got another bar .791" for evo's and shovels.
My ideas for a future seat runout guage were most borrowed from pics Bill Jones over on the Speedtalk forum posted, with a few changes.
Post pics of your stand, if you can, I always like to look at stuff like that, you can only look at so many pics of cam bearings and intake ports!
I tried to post the bigger pics on this post, but it would only let me remove them, the bigger pics are on post #5
Last edited by hightop : 10-31-2009 at 11:15 AM.
Reason: clarification
|
Linear Mode
