Put a 24T in place of the stock 25 tooth and had to adjust the primary up very high to get the proper sag. Just got back from a 3000 mile trip and cleaned up the bike and when I drove it into the garage noticed it was making a racket coming from the primary. Not sure if it is chain slap or my VPC Aim rubbing on the primary cover. I installed the VPC right before I left. Since I was in Canada I was wearing a helmet all the time and am wondering how long it has been making that racket. I will pull it open tomorrow and see. Do you think there is not enough clearance for the VPC it seemed like a pretty close fit on my 06 and I know they sell spacer covers.
__________________
06 CVO 113 Ultra
SE MVA Heads
SE 251
SE 50mm TB
SE 10.5:1
ThunderMax ECM
Zipper A/C
AIM 92T VPC
D&D Fat CAt
3.37 Final Gearing
To solve the primary problem, a baker DD6 shoe fits great with that 24 tooth setup. Its much fatter and doent need to get jacked up so high.
As for the Vpc, only way to check is pull the derby and look for rub spots.
__________________
Hillside Cycle custom head work
S/E 4.375 forged crank Darkhorsed
Axtell 117 cyls and pistons
Mikuni HSR48
S+S Super D manifold
Black Boarzilla
Wood's TW9BG cams and KF325 filter
Linear Mode
