Clutch not working

[Kyddworks]

Any ideas after washing a bike that the that does not work anymore. Mine was working perfectly until after wasing it. Started it up today pulled in the clutch, shift it in first and the bike jumped. I tied adjusting the clutch but no luck there. I have a primo 3" open belt drive with a 6 speed trans. Any ideas welcomed because I'm all out. Thanks

[Kyddworks]

I found what happened and will share in case anybody else has has or had the same problem. A couple of the Clutch/Friction Plates were sticking together. I took them out, soaked and washed them in warmed water. Then I lightly oiled them before putting them back in. Works better now than it did before.

[tapper0112]

Ditto on the clutches sticking..have taken mine apart in a parking lot and "sanded" them on the sidewalk..put back together and good to go!

[muffinman]

That's hard man!