w6s in Ultima shovel

[strokerjlk]

Anybody thinking about running the woods w6s in the new ultima shovel?
My post informing shovel lovers about a new shovel to the market was deleted .
I wasent trying to advertise just inform people that there is a low dollar alternative. I replied to a ultima thread a while back and it wasent deleted.I can only assume that this one was deleted was because I posted the co that you can buy it from. I see people posting about bobby woods products, prices , website all the time so since I haven't seen woods or ***** listed as a sponsor maybe if I combine the two togather my post will not be deleted!
Nothing personal against Bobby!! Just making a point
Here is the info on the Ultima shovel.If interested contact a site sponsor!


Bore: 3.625" Stroke: 4-625" Compression: 9.5:1
Estimated rear wheal HP 90 and Torque 95 (numbers vary depending on Carb setup)

[Hillside]

96" Shovel should roll down the road smartly!

[DD Slider]

Originally Posted by strokerjlk

Anybody thinking about running the woods w6s in the new ultima shovel?
My post informing shovel lovers about a new shovel to the market was deleted .
I wasent trying to advertise just inform people that there is a low dollar alternative. I replied to a ultima thread a while back and it wasent deleted.I can only assume that this one was deleted was because I posted the co that you can buy it from. I see people posting about bobby woods products, prices , website all the time so since I haven't seen woods or ***** listed as a sponsor maybe if I combine the two togather my post will not be deleted!
Nothing personal against Bobby!! Just making a point
Here is the info on the Ultima shovel.If interested contact a site sponsor!


Bore: 3.625" Stroke: 4-625" Compression: 9.5:1
Estimated rear wheal HP 90 and Torque 95 (numbers vary depending on Carb setup)

That sounds about right, I've seen a dyno printout on an 80" shovel w6s cam thunderheader and thunderjet, S&S heads and 9.5 - 1 forged wiseco pistons put out 79.8 HP and 90lbs torque
I am building that same motor for my 83 WG

[strokerjlk]

Originally Posted by DD Slider

That sounds about right, I've seen a dyno printout on an 80" shovel w6s cam thunderheader and thunderjet, S&S heads and 9.5 - 1 forged wiseco pistons put out 79.8 HP and 90lbs torque
I am building that same motor for my 83 WG

SOUNDS LIKE A SWEET RIDE!
LOVE THEM SHOVELS!