Replaced my rear brake light for a fatbob light on my 05 WG,fits the contour of fender so much better.I am trying to figure out what to do with the circuit board that all the wires were tied into.It was inside the stock light housing,just want it to stay dry I greased all the connection's with dielectric grease.Any ideas on what I could use to cover it?Sorry trying to explain it as best as I can.l
No it pretty much has to stay by the taillight it is about 4"L x1" H x 1"thick.The main harness plugs into this, then each blinker plugs in Left/right then the taillight.I had to snip the taillight wire and splice in the new light.I look into the shrink wrap and see if that leads me anywhere
Linear Mode
