Looking for a starter map to run until I get a full Dyno run. Pretty common setup but seraching for all of the criteria is a little tough!
96" TC
Heads ported and polished
9.8:1 compression
Andrews 37N cams
Supertrapp 2-1
.030 head gasket
I guess that would help huh....Sorry about that.
2003 Road King Classic. Still have the old PCIII with the 9pin connector but she keeps ticking along with no issues!
Anyone out there with anything close? Should be firing up tomorrow. My current map is for the last set up which had 9:2.1 and Andrews 26 cams. Any idea if it will be close?
If the bike was running well with the old map then it will be fine to start from there. You may want to richen the map up by say 5% over all just to be safe.
I looked at the cam specs for both cams and they are not radically different. JUst take it easy on the engine until you can get it tuned properly.
Linear Mode
