Last weekend I put my laptop in my tour trunk to log some Auto-tune data for the first time. When I ran my Monitor replay it only displayed my engine's RPM's within the 950± to 1050± range (as if it was idling). I activated the 'show gauges' and 'monitor logging' and also left the default monitor set-up for showing gauges as all checked. During my 15 minute ride I ran my bike up to 4000+ RPM's a couple of times. Am I missing some important steps to see and review my data after a logging session, or could I have a bad TPS??
Any helpful suggestions are greatly appreciated.
Update 5/24/09:
It seems to be working OK again... no cause discovered as to why it would not show it's display before.
Today I globally retarded my ignition timing by 2° from about 2000 RPM's and up, and it seems to be running & sounding waay better!! My pre-ignition pings from twisting my throttle at 2200+ RPM's are now just a thing of the past, so my bike is now finally a happy sow.
__________________
2007 FLHTC
SE Mufflers & A/C
TMAT map 554 (revised)
Arne J., Bothell, WA
My bike maintains my sanity.
Linear Mode
