Mini 02 sensors from Delphi

[HDMD88]

I wouldn't be too surprized if you all don't see these in a week or two for the new 2010 touring bikes......

[claydbal]

doc, i cnt see it. paid members only can see attachments. i see its PDF, could you email? or link?

you still got my email dont ya?

hoping all is well!

[claydbal]

BTW, "mini" sounds like just enough to throw the aftermarket tubing benders into a hissy. i assume they are still narrow band?

[HDMD88]

Originally Posted by claydbal

doc, i cnt see it. paid members only can see attachments. i see its PDF, could you email? or link?

you still got my email dont ya?

hoping all is well!

Dennis, I can't open it either and I posted it....lol...this forum is a piece of work that's for sure.
I'll see about emailing it to you
Yes it is still a narrow band switching 02 sensor, wide bands are not fast enough to report to the ECM and then the ECM make adjustments in the map in the right spot.
Doc

[claydbal]

LOL, i knew you couldnt see it either, but zipped my flapper. thanks for the reply. will look for the email. sounds interesting in the least! and gives us more placement options if mini means mini.

peace-out!

[TXCHOP]

Man, i seen a ton of 02's in my life, but those things are TINY!!!!

Any drawback of the size you see Doc? They look like the next step in the right direction.
Then again as we get more technology everything becomes smaller. Thanks for the "hint".

Stay cool down there in FL Doc!

[HDMD88]

Originally Posted by TXCHOP

Man, i seen a ton of 02's in my life, but those things are TINY!!!!

Any drawback of the size you see Doc? They look like the next step in the right direction.
Then again as we get more technology everything becomes smaller. Thanks for the "hint".

Stay cool down there in FL Doc!

Ohhhhh it's hot here Danny, thank God for this pool....lol
No draw backs on these little guys, matter of fact they have built them better than the ones we had in the past. We'll see how they hold up....time will tell. One good thing about being smaller they will be easier to get at and since they are heated they don't have to be placed so close to the exhaust port any more.....

[Rey]

https://delphi.com/shared/pdf/ppd/se...ini_switch.pdf