my new chopper

[01 chopper]

i thought id post sum pics of my new chopper. im gonna change front fender,put sissy bar,an sum engine work this winter so this can be a start an as i change ill post sum pics.

[Rendell]

Why? change it. It's nice the way it is.. Can you post the specs?

[01 chopper]

Mainly the fender is the on sheet metal change. I really like the looks of the more wrapped around front fenders. Think it might improve it alil more. Other than that just a sissy bar a rear seat for the wife. The rest will be performance upgrades. I was gonna paint it too but the black grew on me. Thanks buddy!!!

[Rollmeaway]

Originally Posted by 01 chopper

Mainly the fender is the on sheet metal change. I really like the looks of the more wrapped around front fenders. Think it might improve it alil more. Other than that just a sissy bar a rear seat for the wife. The rest will be performance upgrades. I was gonna paint it too but the black grew on me. Thanks buddy!!!

I can't agree with ya more, the wrap style frt fender definitely helps keep down the sand & dirt into the engine brought up by the front tire.

I went to the Kendall Johnson signature series 11421 which is a nice addition.
http://www.kustomwerks.com/american/...jc/cat_kjc.pdf

I can also see where your coming from when ya mention paint, It sure would give the ride a new fresh custom look. I am sure your imagination will grow just as it did with the black.

Cheers ... & nice ride ya got there

[Rollmeaway]

Now that I got a better look at it, appears you have the ignition conversion kit too.

[01 chopper]

Yea I have it. Thanks man. I had a lot a ideas but I did find I color I liked a lot.

[TimNY]

01
Nice scoot.
Looks like a work in progress. Make it your own.
I really like the rake and the Sporty style tank.
Must be a blast riding ! Looking Good !

[grndpndr]

good lookin cycle for sure...I like a flat black too. maybe black out the spokes and rims and put some flat red pin stripe on em and the bike. just don't go over board with it.

I bought a 44 inch fender blank off of fleabay and carved it up the way I wanted it to look for my front end. I made it match my wheel design. That also gave me the option rolling it as low the ground in the rear as I wanted to...

[01 chopper]

Thanks man! You were actually read my mind. I was thinking of doing sum old school pin striping with a red an silver met. Not a lot of striping just a few an then blackin the spokes up. I just got my new cam yesterday. So I'll be tearing her down this weekend, so I can send the heads out to be redone an ported.

[01 chopper]

I like the fender too!!!