Joined
·
23,376 Posts
You just need to make sure it all fits before you reassemble. Sometimes all it takes is dropping them in place. Some times a little hammer to tap them into the case. I usually taper the base of the insert with a file, just enough to take the sharp edge off of it. And then taper the hole in the jug, just a little.
If you find that the holes are misaligned, as in the jug base wants to twist or side step out of position, the you can't use the inserts.
If you find that the holes are misaligned, as in the jug base wants to twist or side step out of position, the you can't use the inserts.