Quote:
|
Originally Posted by rtb
Springer...thanks much. Very nice job. I may buy a SERT to allow me correct the EFI after the stage I stuff I plan to put on my bike. I've read the SERT manual but didn't see what I think is an important topic covered. Do you know if the SERT will allow me to save my current (i.e. stock) MAP to a file that I can load again later? I would never expect to have to re-load the original MAP, but I'd like to have it just in case. Is this possible? Thanks
|
Unfortunately I do not believe you can transfer the stock MAP or any MAP that is currently loaded into your ECM back to the computer. That is one of the reasons that I recommend saving any and every change that you make as a new file on your PC so if you ever need an old MAP again you have it saved. The dealer can put a stock MAP back in if ever needed.
Again I have limited knowledge on a lot of the specifics so if anyone knows if this can be done, I would like to know for certain also.
Example, you create a MAP and upload it. You then save the MAP as "newpipes.mt5". You have some popping on deceleration. You go in and change a few settings and save the map again as "newpipesdecelpoptest1.mt5". You try it and the popping seems to be gone but you change a few things and try again "newpipesdecelpoptest2.mt5" but the bike now puffs black smoke on decel. you rename the MAP "newpipesdeceltoofat.mt5". Now you can refer back to that in the future to see what you did to cause that effect. You may also then rename the MAP that works as "newpipesnopop.mt5"
.gif&contenttype=gif "Wheeldock.com")
