Joined
·
1,052 Posts
Hi Tote, not sure if you have any experience with the Bassani Pro-Street exhaust or if you could ask Otto for me, but I was thinking of putting this exhaust on an S&S 124" crate engine w/ 10.8:1 cr & 640 cams.
I plan to use the 45 mm Mikuni & Fatcat exhaust that I currently have on my 117", but would like to go back to a 2-2 exh. again after the engine is broke-in. I've read that the Pro-Streets are one of the better 2-2 systems, but have also seen where they have the typical torque dip in the 2500-3200 rpm range. I've also read that this exhaust works better on big CI builds.
I haven't been able to find any dyno results of this exh. on any big CI builds so I was hoping you or Otto might have some experience with these.
Thanks,
Dave
I plan to use the 45 mm Mikuni & Fatcat exhaust that I currently have on my 117", but would like to go back to a 2-2 exh. again after the engine is broke-in. I've read that the Pro-Streets are one of the better 2-2 systems, but have also seen where they have the typical torque dip in the 2500-3200 rpm range. I've also read that this exhaust works better on big CI builds.
I haven't been able to find any dyno results of this exh. on any big CI builds so I was hoping you or Otto might have some experience with these.
Thanks,
Dave