|
lets get this straight...
Quote:
|
Have to agree with Doc, I just adjust the pushrods down .140"- .160" into the lifter and call that good
|
I am installing Leineweber T-7 gear drive cams. 254/258@.053-.603"lift along with a new set of HD 'B' lifters and valve springs with 175lb set pressure(will have to check open lbs). Should I install limiters? My rev limiter will be set @6400rpm. Adjusting .140-.160" into the lifter is done by 'X' amount of flats? No harm to the lifter or valvetrain?
__________________
95" new dyno sheet soon 11:1cr Triple XXX S&S carb w/Green filter
Axtell Prostreet Pistons
SE roller rockers & rocker support
Fueling cam plate, oil pump, & 'B' lifters w/limiters
Leineweber T7 .603" gear drive cams
Larry Long portwork
TwinTec ignition
Baker Clutch
Vance&Hines Outlaw 2into1
3.37's
Pirelli tires
Amsoil
Last edited by Mother : 01-04-2009 at 05:51 PM.
|
