|
You said it made the noise when sitting in neutral and the bike is stopped. Does it ake any noise while sitting in gear, the bike stopped and clutch pulled in? This will tell you if it's on the primary side or tranny side of the clutch.
As far as getting a jam bar, a piece of 6061 t-6 1x 1/4 alumimum bar cut to 9 1/2 inches works just fine on a softail.
1 1/2 for the crank. 1 3/16 for the clutch. Clutch bit is LH thread.
I like to cut the crank socket so that it is flat across the face ( some have a tapered lead in) as the nut is kind of short. I use a lathe but you could grind it with a disk grinder.
Bruce
|
